Job profile of the post of CMA in Indian Railways advertised by RRB
RRB has advertised 183 posts of Chemical Metallurgist Assistant in the pay scale of Rs. 9300-34800 with grade pay of Rs. 4200/- with minimum educational qualification of degree in Metallurgy or Chemical Engineering or M.Sc in Chemistry or Applied Chemistry. Chemical and Metallurgist is very small organisation in Indian Railways. The cadre is mostly concentrated on Research Design and Standards Organization in Lucknow. The responsibility of the cadre is for preparing the specification and testing of materials used for different applications. The major laboratory is located at RDSO. In Railways, the laboratories are located in every workshop and locomotive maintenance sheds. The most important responsibility of these laboratories is to carry out conditional monitoring of axle for cracks through ultra-sonic flaw detector, grease for ferrous content, dissolved gas analysis of transformer oil for incipient fault in its winding, checks on diesel fuel, lubricating oil, rubber materials, Ferrous and non-ferrous material, brake blocks etc. It also undertakes quality check on the material specification as per the need.
The organization is very small headed by a Junior Administrate or Senior Scale officer in a Railway under the overall control of Mechanical Department.
The promotion to the next grade is not a problem, but the major issue is promotion to officer grade because of the very limited number of posts. Unless the cadre restructuring is undertaken in the near future, there is every possibility of superannuation in the grade pay of Rs. 4600/- with little hope of promoted to the level of ACMT i.e. Junior scale level officer. However, the situation in RDSO is different, where a degree in Chemical and Metallurgical engineering makes you eligible for the post of (Chemical and Metallurgical Superintendent) CMS in the grade pay of Rs. 4600/- but not so in Railways. The number of Assistant and Senior Scale officer posts is also very large in number, therefore, providing an adequate promotional avenue. There is a possibility that this discrepancy will be observed and corrective action initiated to avoid discontentment in the cadre. Except this aspect in the cadre, there is nothing wrong, and one should prepare with full throttle as there are limited scope for job opportunities for Chemical and Metallurgical Engineers to find opportunity in Indian Railways.
The working hours are not very strenuous and not requiring working beyond schedule hours. You can conveniently make use of the free time to acquire higher qualification or knowledge bank. The knowledge of Railway working, specification, testing procedures is a privileged experience any may give you openings in Private or PSU sector.
The posting is at the places of the location of Railway workshops and Locomotive maintenance sheds. The place of posting may be a small or near a major city. The posting is stable with almost negligible transfers and that too when promoted to the officers grade.
For
Study material and mock test on Environment and Pollution Control
Mock test on General Awareness
You may also like:
- Multiple choice questions on Mathematics for competitive examination Test 10
- Help to understand job profile of NTPC vacancies advertised by…
- Multiple choice questions on Mathematics for competitive examination Test 6
- Multiple choice questions on Mathematics for competitive examination Test 7
- Multiple choice questions on Mathematics for competitive examination Test 9
- Multiple choice questions on Mathematics for competitive examination Test 8
Hi All
I have been selected for document verification by RRB Chennai for the post of CMA (chemical and metallurgy assistant).
While applying I had opted for SR and ICF. What does SR (Southern Railway) mean relating to place of posting? Will it be Chennai or Tichy, Salem are also considered as possible place of positing?
Can someone also shed some light to the following questions also. Please
1) How is the promotion offer
2) transfers
3) scope for knowledge
4) any foreign trips available
5) is it research oriented or only testing
6) How much will I get as a take home salary at the initial stages.
7) Will there be frequent increments in salary
8) Health risks associated with the job
9) Timings
10) Other perks available.
11) Work Environment
Eagerly awaiting your reply.
Thanks
Sridhar
CMA is a junior level supervisory post. I have written about the future options on my blog https://globalrailelectrica.com/job-opportunities-in-rail-transport/job-profile-of-the-post-of-cma-in-indian-railways-advertised-by-rrb/. However, your quarries are answered as follows:
SR means posting in workshop or electric or diesel maintenance loco shed. The actual place of posting will be decided depending upon the vacancy in different units on the day of joining.
1. Not very excellent 2. Negligible 3. quite good 4. Negligible and very unlikely 5. Testing only 6. Your advertised basic plus DA and grade pay 7. yearly increment and no out of turn increments. 8. Negligible 9. Schedule working hours as that of the unit in which you are working 10. Nil except advantage of free 3 sets of privilege passes for travel in any part of the country 11. Reasonably OK
You may join and still keep on try for better opportunities in other private and PSUs.
Hi Mahesh
Thank you for your reply.
But I am more interested on the city of posting. Will it be Chennai only or some other city is also possible?
i am appearing for the very first time. can you please send me the previous year paper. I really need it.
Thanks
Visit https://globalrailelectrica.com/category/railway-job-test-preparation/page/1/….9 and you will get all sets of question papers but for mock drill exercise along with many more mock drill exercise where you can check your preparedness.
Sridhar can u pls wht type of question ask in paper and wht is its cutoff?
hello sridhar,can u tell me the cut off for cma for ur batch as u experienced this earlier,like i gave my exam this august and waiting for results,i got 73 obc ,any chances?
HI SRIDHAR…I ATTENDED THE CMA FROM RRB MUMBAI 02/2014…I GOT APPROX…65 MARKS GREEN SET OBC…
BRO CAN U ANALYSE CHANCES OF GETTING JOB…FOR ME…PL…
Hi ,please suggest some books for technical portion of RRB CMA
Job profile and promotions sir
Sir I hv null about it I hv some suggestions how to prepare for CMA
Sir give me Ur no..
You may post your query on the website and may also examine the reply to the queries submitted by others for better understanding.
Sir is there any security bond in rrb cma?
Please check the terms and conditions stated in the advertisement.
Sir what about your education qualification and how much marks you got in cbt1 and cbt2??
Sir what is your education qualification? How much score you got in cbt 1 and cbt 2
Hii I want information . I am selected for rrb cma post .
JAIN SIR, FIRST OF ALL THANK YOU FOR YOUR VALUABLE CO-OPERATION TOWARDS THE JOB SEEKERS…
I NEED YOUR HELP & PROPER GUIDENCE….
I AM A WAIT LISTED CANDIDATES, IN CMA, UNDER RRB KOLKATA…
I BELONG TO #SC CATEGORY…
I RRB KOLKATA, 53 ARE IN THE MAIN LIST & 16 ARE IN THE WAITING LIST…
LIST ARE GIVEN ON THE BASIS OF ROLL NO. NOT BY MERIT…. SO, PLS GIVE MY ANSWER…
1. HOW MUCH POSSIBLITY OF GETTING JOB???? ( ON DV, 27 APRIL, THERE ARE 2-3 PERSON ABSENT ONLY)
2. IS THERE ANY POSSIBLITY OF INCREASING VACANCY NO.,??? THOUGH ANY CORREGDUM VACANCY DO NOT PUBLISH TILL NOW.
3.AS A SC CATEGORY CANDIDATES, HOW MUCH CHANCES ARE THERE TO COME TO THE MAIN LIST???
PLS, HELP ME & REMOVE ALL MY ANXITY, TENSION BY GIVING AUTHENTIC SUGGESTION…
THANKS A LOT..
i am appearing for the very first time. can you please send me the previous year paper. I really need it.
Thanks
Can you please tell me about the job profile of chief depot material superintendent and also about the posting places working hours etc.
I am applied for CMA Allahabad, can u please tell me what should be cuttoff for it approx for General cat.?
How does it matters to you Ajay? Your preparation will remains the same. Plan for minimum 70% marks to be sure for a call.
But, last year chennai board cuttoff for general is 42 marks.
It may go to 40% depending on the number of candidates appearing in the examination. It is lowest supervisor category post in IR cadre system and there is a possibility of few applicants. The person holding engineering degree is appearing is eligible for Senior Section Engineer where as it is Junior Engineer for Mett and Chem. engineering and there is possible of less applicant. Here also, there are 16 posts and with not many candidates the chances are good for anyone to get selected with low cut off.
for banglore ur 47% obc 46%
I hope you are the lucky one
hi good morning Srinivas….I applied for the post CMA in the Bangalore region this year throgh the advt. no. CEN1/2015. There are totally 10 posts in which only 7 are for UR. So can u please tell me the possible cut off marks???What is the minimum marks i have to secure to enter the job????
ajay it is for …which notificatn bro…2012 or 2014 ?
suddesh it is 46% i,e 69 marks for obc..
i got 55 for cma in rrb secbad region, any chance?
Difficult to suggest as it depends on large many factors. Hope for the best
when will rrb 2015 results come?
If a person is initially posted in the workshop as CMA then there is any way to transfer to RDSO?
Very unlikely
How to check the cut off marks of the previous examination in the official website?? i tried so many times but i did not get the link…only Chennai RRB is posting the cut off marks…all other RRB s are not…
hi sir…
what is the cut off marks for chemical&metallurgical assisatnt rrb mumbai ..(obc) of previous notification
i.e, 01/2012
Hi
I am presently employed in a private sector and I have been selected for this post. I would like to know the grace period railways will give me for joining as I cannot shift jobs overnight. I have a notice period of 1 month in my present company. How much time from railways for notifying my company?
Thanks
Sridhar
You should write to the authority seeking additional time for joining due to constraint as mentioned. The grace period shall be given.
i am studying msc chemistry first year , 2nd year study inorganic chemistry my specialtion i have selected cma post but rrb rejected.andrauniversity given my original degree msc inorganic .i am not eligible this post give me sugission sir
Sorry I cannot comment on this
Chemical and metallurgical post when release ?
i have been selected as cma in west central railway. i want to know about promotion aspects, training period, bond{if any}.
also please clear the doubts if this post is now under 4600 grade pay, after few changes in 7th pay commission.
Dear Sir, I am selected for CMA post in SWR. But, confused about joining as the 5 year indemnity bond is too confusing. It says I should pay training fee and other pay to break the bond. Also, I had applied through RTI about this post. They had replied that CMA vacancies are not available and successful candidates will be appointed to CMS posts with higher grade. But, I find in the offer letter that they have given CMA post only.
In RTI u have asked about Bond whereas your quarry is about the offer is of CMA and than vacancy of CMS. CMS is higher grade post and they cannot offer this post to the candidates selected for CMA. After the offer is given, they cannot say now that the vacancy is now available. I am unable to understand the relation between the two things unless all the documents are seen. You may approach the CPO of the concerned Railway.
Sir… please..can Chemical engineering degree student apply for Chemical and metallurgical assistant post??
I want to attend rxam2017of CMA please inform me
The advertisement is not every year. I don’t think it will be advertised even in 2018.
Hello sir,
Is there any chance for this post in 2019 or 2020
Hello sir,
Is there any chance for this post in 2019 or 2020
I hope it should be in 2019.
Hello Mahesh sir
I m studying in MSc part2. I want to prepare for chemical & metallurgical assistant post so plz suggest me books for preparation & i couldn’t finding the question paper of CMA plz tell me the approach for finding previous year exam papers,
And tell me what is difference between CMA & CMS ?
There are no ready books for a specific examination. What I suggest you to read the syllabus carefully and prepare yourself all the subject. Since you have sufficient time of at least one year for preparation, revise all that has been studies during academics and I am sure that will benefit you more than any other system.
Hello sir,
Will there be any recruitment for RRB CMA in 2018 ?
Dear ma’am….
Can MSc chemistry student apply for Chemical and metallurgical assistant post?
Please give me material for chemical and matergical assistant. Only Subject material
I don’t have
Please suggest books for technical part of RRB CMA
Mujhe batana please any book for CMA post
Pl remember there is no book for CMA or any other RRB examination. I had elaborated on this website how to prepare for the examination.
How to prepare for CMA ? Can you please share the strategy as I’m going to appear for Rrb cma 2019?
pls tell
If any one tell b.pharmacy condidate eligible for chemical assistant??
I am not sure. The qualification criteria do not include this degree.
Dear sir..
Can Chemical engineering degree student apply for Chemical and metallurgical assistant post??
Please reply.
saivinayiv@gmail.com
Degree finished
Sir chemical & metallurgical assistant के CBT2 में जो Physics & chemistry आती हैं वो कोनसे लेवल कि आती है?
मैरा मतलब कि 12th standard या B.sc standard
Plz reply soon..and suggest me books for CBT2
I am Naval Meena . Bsc complete in physics, mathematics,chamistry. RRB रासायनिक और धातुकर्म सहायक(CMA) ke tarye kayre Kishor type se Karu . Help Karine ke liye 7610072203 par cell kare
my special subject is t.y.b.sc physics
can i apply for CMA post 2019 mumbai plz reply me
go through qualification prescribed and the best way to identify eligibility.
It has 5days working or 6days? And is there working in shifts?
Is there any security bond in rrb cma? Please reply
Sir, thanks for the given info. I am selected as a CMA in SER region..will you please tell me the possible training centres in this region for the same post.
Likely to be at KGP workshop